Conservation of Momentum and gravity

AI Thread Summary
In the ballistic pendulum experiment, a bullet is fired into a stationary block, causing the block to rise and swing. The maximum height reached by the pendulum is 3 cm, and it subtends an angle of 36.9° at that height. The conservation of momentum and energy principles are applied to find the final velocity of the block and bullet system after the impact. The initial momentum equation is mv = (m + M)V, and the energy conservation equation is 1/2 * (m + M)V^2 = (m + M)gh. The student is struggling with the calculations and the application of trigonometry in this context.
jcjp
Messages
1
Reaction score
0

Homework Statement


A student performs a ballistic pendulum experiment using an apparatus similar to that shown in the figure. Initially the bullet is fired at the block while the block is at rest (at its lowest swing point). After the bullet hits the block, the block rises to its highest position, see dashed block in the figure, and continues swinging back and forth. The following data is obtained: the maximum height the pendulum rises is 3 cm, at the maximum height the pendulum subtends an angle of 36.9◦, the mass of the bullet is 97 g, and the mass of the pendulum bob is 788 g. The acceleration of gravity is 9.8 m/s2 .


Homework Equations



I thought this was the equation I needed to use: (1/2)(m1+m2)v^2 (final) =( m1 +m2)gh
(to solve for v(final))

Along with: (m1+m2)V (initial)= (m1 +m2) v(final)

The Attempt at a Solution



I continually get around 2.277, yet I know that's wrong.

Also, I don't really know where the trig is applied...
 
Physics news on Phys.org
jcjp said:

Homework Statement


A student performs a ballistic pendulum experiment using an apparatus similar to that shown in the figure. Initially the bullet is fired at the block while the block is at rest (at its lowest swing point). After the bullet hits the block, the block rises to its highest position, see dashed block in the figure, and continues swinging back and forth. The following data is obtained: the maximum height the pendulum rises is 3 cm, at the maximum height the pendulum subtends an angle of 36.9◦, the mass of the bullet is 97 g, and the mass of the pendulum bob is 788 g. The acceleration of gravity is 9.8 m/s2 .

The Attempt at a Solution



I continually get around 2.277, yet I know that's wrong.

Also, I don't really know where the trig is applied...

The question doesn't say what you have to compute and I only know that you "get around 2.277 and that it's wrong" (what quantity? units?) so I'll just outline the general approach.

m - mass of the bullet
M - mass of the block
v - speed of the bullet
V - speed of the block+bullet system
h - distance the system rises
K - initial kinetic energy of the system after impact
U - potential energy of the system at the highest position

To get the speed of the system after the impact just apply the conservation of momentum:

mv = (m + M)V

Then conservation of energy:

K = U

K = 1/2 * (m + M)V^2

U = (m + M)gh

The rest is just rearranging and substituting.
 
jcjp said:
...

Along with: (m1+m2)V (initial)= (m1 +m2) v(final)

...

This looks to be the problem, since only the bullet is moving initially, the block is at rest.
 
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
TL;DR Summary: Find Electric field due to charges between 2 parallel infinite planes using Gauss law at any point Here's the diagram. We have a uniform p (rho) density of charges between 2 infinite planes in the cartesian coordinates system. I used a cube of thickness a that spans from z=-a/2 to z=a/2 as a Gaussian surface, each side of the cube has area A. I know that the field depends only on z since there is translational invariance in x and y directions because the planes are...
Back
Top