Designing a 10-HP 3-Phase Induction Motor: Where to Buy Parts in the USA?

AI Thread Summary
For a graduate project focused on a 10-hp 3-phase induction motor, several companies in the USA supply necessary parts like stators, rotors, and frames. One recommended resource is Motion Control, which offers a variety of motor components. Participants in the discussion emphasize the need for reliable suppliers similar to Digi-Key for electronic parts. Additional suggestions for sourcing motor accessories may include exploring specialized motor companies. Overall, finding the right suppliers is crucial for meeting design specifications effectively.
SNOW4E
Messages
2
Reaction score
0
hello everyone
my graduate project is 10-hp 3-phase induction motor

can anyone teel me where to buy parts (stators,rotors,frames...etc) from USA
or any other

i need the company (or shop) site so i choose the required one for my design specification
something like digikey for electronic components but i need it for machine accessories

thanks all:smile:
 
Engineering news on Phys.org
how about this?
shows a list of companies. this is just a few. I've look into motor companies before lots of companies when i wanted get dc, brushless and steppers.

http://www.motioncontrol.com
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Induction motor rotor design features
Replies
4
Views
2K
Induction motor windings, number of turns per phase and per pole
Replies
2
Views
4K
Sizing the start capacitor for an induction motor
Replies
2
Views
4K
Single phase Induction motor Design
Replies
3
Views
3K
Why single phase induction motors are used for fractional HP applications
Replies
9
Views
2K
How to design a single phase induction motor
Replies
3
Views
5K
Rotor and stator flux in 3 phase Induction motor
Replies
14
Views
7K
Battery Powered Electric Motor and Charging Requirements
Replies
5
Views
3K
Squirrel cage induction motors - rotor issues
Replies
6
Views
4K
Using 400V 50Hz 3 phase motors with 240V single phase 60Hz
Replies
14
Views
7K

Hot Threads

Recent Insights

Back
Top