Device simulation with Silvaco ATLAS

AI Thread Summary
To simulate interface traps in a power MOSFET using Silvaco ATLAS, adding a sheet charge at the interface is recommended, which is managed through boundary conditions. Users with older versions of ATLAS may face challenges, such as the inability to utilize a self-created SPECT file as an input. Assistance is sought for plotting the electroluminescence (EL) of the organic04 example. The discussion highlights the need for specific guidance on input file compatibility and simulation parameters. Effective simulation requires understanding the tool's capabilities and limitations regarding interface traps and file formats.
biju4u90
Messages
1
Reaction score
0
How can I give interface traps while simulating a power MOSFET in Silvaco ATLAS tool?
 
Engineering news on Phys.org
One way to simulate interface traps in silvaco is to add a sheet charge at the interface. This is controlled by the boundary conditions defined at the interface.
 
i have an old version of atlas and it dosent have spectrum library so i create a SPECT file myself but i can't use it as an input file,please help me, i want to plot EL of organic04 example
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Similar threads

For those who use Atlas Silvaco
Replies
3
Views
3K
How to add HZO as an Oxide gate in Silvaco TCAD?
Replies
1
Views
2K
Help using Atlas Silvaco to simulate an OLED
Replies
5
Views
2K
How to include an ITO layer for Anti-Reflection Coating in Silvaco?
Replies
1
Views
2K
Silvaco TCAD question -- adding texturing
Replies
10
Views
2K
What's the Athena (Silvaco) code for pyramid texturing on a solar cell?
Replies
10
Views
962
Silvaco IC simulation with Athena Atlas
Replies
3
Views
6K
Si Bandgap in Device Modeling (Silvaco Atlas)
Replies
1
Views
4K
I Maximal atlas of topological manifold
Replies
37
Views
3K
What are the top simulation techniques for semiconductor devices?
Replies
1
Views
529

Hot Threads

Recent Insights

Back
Top