Diametral Pitch: Pinion & Gear Compatibility?

  • Thread starter Thread starter Quadruple Bypass
  • Start date Start date
  • Tags Tags
    Gear Pitch
Quadruple Bypass
Messages
120
Reaction score
0
if the diametral pitch of the pinion is x, would the diametral pitch of the gear also be x?
 
Engineering news on Phys.org
Mating pairs will have the same diametral pitch.
 
Thank you kind sir.
 

Thread 'Query on Isentropic relationships (such as PV^gamma = constant)'

Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
View full post »

Thread 'Dry sump pump issue'

I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
View full post »

Similar threads

Gears - Hobbing gears with similar base pitch
Replies
6
Views
1K
Difference between contact pattern and mounting distance for a pinion gear?
Replies
2
Views
1K
Rack and pinion, motor selection method
Replies
16
Views
21K
Why are we not seeing more variable-pitch quadcopters?
Replies
2
Views
2K
Gear and gearbox design - circular pitch
Replies
15
Views
5K
Gear teeth force from the rotation angle
Replies
8
Views
2K
Concerning the Airfoil of Variable Pitch propellers
Replies
2
Views
2K
Finding coincident angle between 2 equally spaced sets
Replies
1
Views
1K
What is/how do i measure the module of these bevel gears?
Replies
1
Views
6K
Mount Rack & Pinion Interference in PTC Creo | Avoidance & Solutions
Replies
4
Views
2K

Hot Threads

Recent Insights

Back
Top