Do you have any suggestions for a mechanical student's project?

AI Thread Summary
A mechanical student is seeking project ideas for university, focusing on either hardware or software. They express a particular interest in passive solar technologies, specifically passive cooling systems. The student is looking for suggestions, links, and resources to help finalize their project title. They emphasize the need for assistance in this decision-making process. Engaging with the community for ideas and references is encouraged.
soonsoon88
Messages
53
Reaction score
0
I am a mechanical student, i have to take a project in my university.
However, i am still facing probelm in choosing title of project.
The project can be either hardware or software.
For hardware,
i am quite interesting in passive solar. such as passive cooling.
Do you all have any suggestion, link and webpage for me to refer?
I need help =(
 
Engineering news on Phys.org
soonsoon88 said:
I am a mechanical student, i have to take a project in my university.
However, i am still facing probelm in choosing title of project.
The project can be either hardware or software.
For hardware,
i am quite interesting in passive solar. such as passive cooling.
Do you all have any suggestion, link and webpage for me to refer?
I need help =(

http://www.google.com/
 
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top