Eeprom 27C2001 /P: Low vs High Settings

Thread starter tnecniv
Start date Dec 3, 2011

Dec 3, 2011

tnecniv

May i know what is the different between setting low or high for /P of eeprom 27C2001

Engineering news on Phys.org

Dec 4, 2011

MATLABdude

Science Advisor

You can find that information under the Programming section of the datasheet which I found using Google:
http://www.datasheetcatalog.com/datasheets_pdf/2/7/C/2/27C2001.shtml

Thread 'When 50,000 volts go through a wire at 5,000,000 FPS - The Slow Mo Guy'

View full post »

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...

View full post »

Thread 'EMF (Electromagnetic Field) & EHS (Electromagnetic Hyper Sensitivity)'

Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...

View full post »