Electrical appliance which is labelled 240V, 2000W

  • Thread starter Thread starter Kyoma
  • Start date Start date
  • Tags Tags
    Electrical
AI Thread Summary
Plugging a 240V, 2000W electrical appliance into a 250V source may not cause damage if the appliance has a wide voltage tolerance, but excessive voltage can lead to failure. Conversely, connecting it to a 230V source typically allows the appliance to operate, albeit potentially at reduced performance. Most modern appliances are designed to handle slight voltage variations without issue. However, significantly exceeding the rated voltage can result in burning out the appliance unless protective mechanisms are in place. Overall, voltage tolerance varies by appliance, and it's crucial to consider these factors for safe operation.
Kyoma
Messages
95
Reaction score
0
electrical appliance which is labelled " 240V, 2000W "

If you have an electrical appliance which is labelled " 240V, 2000W ",

What will happen if you plug it to an electrical source of 250V? Will it get burned? What will happen if you plug it to an electrical source of 230V? Will it work?
 
Physics news on Phys.org


That depends on the appliance. In most cases, I would think it would be fine. Some modern power supplies for appliances are tolerant of an extremely wide range of input voltages (~90-260 V or so).
 


Nothing would happen if the voltage supplied is lower, right? Except may be the appliance won't work till the required voltage is supplied?
 


Considering the electrical appliance as a simple form of resistive load, such a slightly high voltage than rated capacity should not burn it but if the voltage applied is very high, then definitely it will burn the appliance, (unless protected by some other sophisticated mechanism). Similarly, lower voltage would give lower output from the appliance.
 
I was using the Smith chart to determine the input impedance of a transmission line that has a reflection from the load. One can do this if one knows the characteristic impedance Zo, the degree of mismatch of the load ZL and the length of the transmission line in wavelengths. However, my question is: Consider the input impedance of a wave which appears back at the source after reflection from the load and has traveled for some fraction of a wavelength. The impedance of this wave as it...

Similar threads

Back
Top