Engineer vs. Math: Solving the Calculus Conundrum

  • Thread starter Thread starter redgoat
  • Start date Start date
  • Tags Tags
    Engineer
AI Thread Summary
Electrical engineers should be proficient in solving calculus problems, particularly those encountered in their coursework, although some may find certain problems more challenging. Mastery of calculus is essential as it underpins many concepts in electrical engineering. Taking additional applied math courses is recommended to enhance problem-solving skills. While it's acknowledged that some calculus problems may remain unsolvable, a strong grasp of the fundamentals is crucial for effective engineering practice. Ultimately, personal effort and commitment to mastering these skills are key to becoming a successful engineer.
redgoat
Messages
37
Reaction score
0
Should every electrical engineer be able to figure every calculus problem out?
 
Engineering news on Phys.org
If you are referring to problems given in calculus courses required for an EE program, I feel an EE would be able to solve them all (some problems may take more time than others, that's all).

Perhaps, depending on the instructor, some may challenge a student by throwing in a few tougher questions.
 
To be a good EE, you should take some extra applied math courses, especially on methods of solving problems. Ultimately, its not just about the minimum you need to get by, but your personal best.
 
Yes, Because The Calculus Is One Of The Mathematical Methods Used To Described The Phenomenon In The Field Of Electricity...
 
Should a tennis player be able to return every serve?
This question has no answer either.

There will always be a calculus problem you can't solve.
But without a serious effort to master the fundamentals of engineering
(and calculus is one of these) you will not become an effective engineer.
 
Antiphoton is ryt!
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top