Finding equivalent resistance between two points in a circuit

5 replies · 3K views · last reply
Arka420
Messages
28
Reaction score
0

Homework Statement

: [/B]Given the circuit diagram, find the equivalent resistance between points P and Q.
Hand-drawn circuit diagram with terminals P at top left and Q at bottom left, connected by a network of resistors arranged in a grid-like pattern.

Homework Equations

: [/B]ΔVloop = 0, ΔIjunction = 0 and V = IR

The Attempt at a Solution

: [/B]Eliminating the wires with no resistors and solving for resistance gives me the answer as (11/10) R, which is not the answer. I'm confused as to which resistors are in parallel and which resistors are in series.
 
Last edited by a moderator:
Perhaps start by numbering the resistors A, B, C etc and post the drawing again.

Tell us which you think are in series or parallel. For example "I think A is in series/parallel with..."

Normally this type of problem is simplified by replacing two resistors in series or parallel with one and redrawing the circuit. You've posted the original so show us the first step/simplification that you made.
 
Arka420 said:

Homework Statement

: Given the circuit diagram, find the equivalent resistance between points P and Q.
Hand-drawn circuit schematic with terminals P at top left and Q at bottom left, joined by a network of five resistors and several wires forming a grid-like arrangement.
[/B]

Homework Equations

: ΔVloop = 0, ΔIjunction = 0 and V = IR[/B]

The Attempt at a Solution

: Eliminating the wires with no resistors and solving for resistance gives me the answer as (11/10) R, which is not the answer. I'm confused as to which resistors are in parallel and which resistors are in series. [/B]
Post your working out. We have no way of knowing where you went wrong (and therefore how to help you/ correct any mistakes) if we can't see your reasoning, but the attempt at the problem appears to be right (eliminate the short wire and simplify using the rules for resistors in series/ parallel).
 
Remember also the rule that if multiple resistors have the same voltage drop associated with them then they are parallel
 
This is how I worked out the circuit. Is it correct?
Hand-drawn circuit schematic with terminals labelled P and Q; resistors are arranged in a network of parallel and series branches between the two terminals, with one resistor in a short side branch to the right.
 
Arka420 said:
This is how I worked out the circuit. Is it correct?
Hand-drawn resistor network schematic between terminals P and Q, with several resistor symbols connected in series and parallel branches.
Not correct.

Follow this advice:
CWatters said:
Perhaps start by numbering the resistors A, B, C etc and post the drawing again.

Tell us which you think are in series or parallel. For example "I think A is in series/parallel with..."