Finding Rx for maximum power transfer with Thevenin equivalent

4 replies · 2K views · last reply
Michael_0039
Messages
59
Reaction score
7
Homework Statement
Homework: Rx=? to get maximum power transfer at point M
Relevant Equations
nil
Hi,

after calculations I end up in the circuit below¨ (Thevenin equivalent)

Thevenin equivalent circuit: a 45 V voltage source with Rth = 20 Ω in series with a load RL = 14Rx/(14+Rx), with a node labelled M between Rth and the load.


So now I have to say Rth=RL and I will find Rx ?The initial circuit is this:

Circuit schematic with an 18 V source, resistors of 4 Ω, 10 Ω, 18 Ω, 28 Ω and 10 Ω, a dependent current source labelled 0.4V0 A, a dependent-source reference voltage V0, a resistor labelled Rx, and a node M.

Thanks
 
Michael_0039 said:
So now I have to say Rth=RL and I will find Rx ?
If your working is correct, that's how you solve it, yes. I haven't checked your working.
 
By the way I think this is the way to solve, because we have 2 resistors in parallel:

Handwritten derivation: a 45V source in series with a 20 ohm resistor feeds load RL, where RL = 14Rx/(14+Rx); power P = V^2 RL/(RL+20)^2 is derived and boxed, with notes on RL intervals (0,20) and (20,inf) and RL <= 14 when Rx tends to infinity.

Edit
I mean this:

Hand-drawn Thevenin equivalent circuit: voltage source Vth = 45V in series with Rth = 20Ω, feeding a load box RL containing Rx and 14Ω resistors in parallel.
 
Last edited: