Finding the Degree of Freedom in Mechanics for Scientists

AI Thread Summary
The discussion focuses on understanding the concept of degrees of freedom in mechanics, defined as the minimum number of independent variables needed to describe a system's state under given constraints. Participants seek examples to illustrate this concept further. Resources such as a PDF on free vibrations and a Wikipedia article on degrees of freedom in mechanics are shared for additional context. The conversation emphasizes the importance of grasping this fundamental principle in mechanics for scientific applications. Overall, the need for clear examples and resources is highlighted to enhance understanding.
IPhO' 2008
Messages
44
Reaction score
0
How to find the Degree of freedom (Mechanics) of system?
Thank you so much.
 
Physics news on Phys.org
Um, intuition? Just the smallest number of mutually independent variables required to completely describe any state of the system within constraints.
 
Please give me some example.
 
Thank you so much.
 

Thread 'Average velocity as a weighted mean'

Hello everyone, Consider the problem in which a car is told to travel at 30 km/h for L kilometers and then at 60 km/h for another L kilometers. Next, you are asked to determine the average speed. My question is: although we know that the average speed in this case is the harmonic mean of the two speeds, is it also possible to state that the average speed over this 2L-kilometer stretch can be obtained as a weighted average of the two speeds? Best regards, DaTario
View full post »

Thread '1:1 versus 2:1 Mechanical Advantage debate'

The rope is tied into the person (the load of 200 pounds) and the rope goes up from the person to a fixed pulley and back down to his hands. He hauls the rope to suspend himself in the air. What is the mechanical advantage of the system? The person will indeed only have to lift half of his body weight (roughly 100 pounds) because he now lessened the load by that same amount. This APPEARS to be a 2:1 because he can hold himself with half the force, but my question is: is that mechanical...
View full post »
Thread 'Beam on an inclined plane'

Thread 'Beam on an inclined plane'

Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
View full post »

Similar threads

I Constraints of a mechanical system
Replies
5
Views
2K
I Degrees of freedom and constraints
Replies
2
Views
1K
I Degrees of Freedom in Lagrangian Mechanics for a Fractal Path
Replies
2
Views
1K
When boiling water, what is the degree of freedom inside the vapour dome?
Replies
5
Views
3K
Newton's Laws: Internal Degrees of Freedom
Replies
17
Views
3K
Degrees of freedom (question based on an interview I attended)
Replies
6
Views
2K
Degrees of freedom and holonomic constraints
Replies
15
Views
2K
Why does a wrist have 3 degrees of freedom?
Replies
5
Views
2K
B Conflicting definition of degree of freedom in Kinetic Theory of Gases
Replies
7
Views
2K
Degree of Freedom: Definition & Examples - Confused? Ask Here!
Replies
11
Views
2K

Hot Threads

Recent Insights

Back
Top