- #1
bkhan10000
- 9
- 0
Hey guys,
Trying to design a spur gear but I am very confused as the root circle/dedendum ends up being greater than the base circle. What do I do in this case? The gear I'm trying to design has a 68.33mm pitch diameter, 60 teeth, the pressure angle a standard 20 degrees. What am I doing wrong here? Any help is appreciated!
-Bob Khan
Trying to design a spur gear but I am very confused as the root circle/dedendum ends up being greater than the base circle. What do I do in this case? The gear I'm trying to design has a 68.33mm pitch diameter, 60 teeth, the pressure angle a standard 20 degrees. What am I doing wrong here? Any help is appreciated!
-Bob Khan