Generating vertical vibrations

  • Thread starter Thread starter skyisthelimit
  • Start date Start date
  • Tags Tags
    Vertical Vibrations
AI Thread Summary
Devices that generate vertical vibrations with variable amplitude and frequency can be challenging to find. Pneumatic systems using pressurized inner tubes are a cost-effective option, though they may introduce compression artifacts in the waveform. A counter-rotating eccentric mass exciter is recommended as a simple and effective solution for achieving the desired vibrations. This device is easy to construct and operate, making it suitable for vibrating containers filled with sand. Overall, these suggestions provide practical approaches to generating the required vertical vibrations.
skyisthelimit
Messages
3
Reaction score
0

Homework Statement



anyone have any suggestions for devices which generate vertical vibrations, preferably of variable amplitude (say, up to a cm or so) and of variable frequency (around 10hz) which can be used to vibrate a container full of, say, sand?

Homework Equations



umm...

The Attempt at a Solution



uhh...
 
Engineering news on Phys.org
This could be tough depending on how much sand you are quaking. May I suggest using pneumatics to pressurize something like innertubes? The problem is that the waveform would be full of compression/ pressurization artifacts, the advantage is that its pretty cheap.
 
My sugestion: a counter rotating eccentric mass exciter. It is very easy to build and operate, and it will do the job as you want.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top