Good books for Circuit Analysis?

AI Thread Summary
For basic circuit analysis techniques, several recommended books include those by Alexandre, Dorf, Boylestad, and Floyd. The Hayt and Kemmerly book is noted for its simplification and clarity, making it a good choice for beginners. The discussion emphasizes the importance of finding a staple text similar to Halliday & Resnick in physics. Participants share their positive experiences with these resources. Overall, these titles are considered valuable for learning circuit analysis fundamentals.
Maxwell
Messages
511
Reaction score
0
Hey all, I'm looking for good books or guides on basic circuit analysis techniques.

Is there a book that is known as a "staple" in teaching circuit analysis - like, for example, the Halliday & Resnick book for physics?

Thanks.
 
Engineering news on Phys.org
Here are the names of the books

Hi !


Well i think that the books written by Alexandre, Dorf, Boylestad and Fllloyd on introductory circuit analysis are worth trying..
 
i studied the book by hayt,kemmerly and i found it very simplified and understanding.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top