How Can SolidWorks Help Calculate Air Flow in a Hamster Cage?

AI Thread Summary
SolidWorks can be utilized to calculate airflow in a hamster cage by employing Computational Fluid Dynamics (CFD) simulations, specifically using the Large Eddy Simulation (LES) model for accurate results. Key objectives include improving oxygen levels, reducing odors, and minimizing bacterial growth through antimicrobial design. To achieve this, calculations can be based on Bernoulli's equation and Darcy-Weisbach equations. Learning to effectively use SolidWorks' fluid simulation tool is essential for implementing these calculations in the design. For further guidance on ventilation and HVAC design, resources are available at engineershouse.com.
jjssj
Messages
5
Reaction score
0
Hi

I'm creating a hamster cage for better ventilation(circulation) without too much flow.(draft)
How would I work out mathematically the air flow going into a plastic box. The flow rate etc..
The plastic box will be inside a normal home.

Things I want to know and improve
The overall oxygen level
Reducing smell/bacteria growth-antimicrobial
Implement calculations in a superior design.

Thanks
 
Engineering news on Phys.org
mathematically speaking in order to study such a simulation you need a CFD simulation using LES model for better expectations or you can make the design theoretically without getting into details using Bernoulli's equation and Darcy Weisbach equations, for more information on ventilation design in specific and HVAC design in general visit : http://www.engineershouse.com/
 
I'm using solidworks, i thought that would be the best way.
Just have to learn how to use the fluid simulation tool

Thanks
 
Last edited by a moderator:

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Doublet flow in Fluid Dynamics between two spheres or cylinders
Replies
0
Views
1K
How Can I Calculate Flow Pressure Drop in a Two-Dimensional Diffuser?
Replies
7
Views
9K
Model pressure loss vs time for air in a cylinder w/ hole
Replies
15
Views
4K
Pressure and velocity calculation for microchannel. pls help
Replies
2
Views
2K

Hot Threads

Recent Insights

Back
Top