How Does Current Change with Resistance in Constant Voltage Sources?

AI Thread Summary
In a constant voltage source, as the resistance of a variable resistor changes from zero to infinity, the current through the resistor varies according to Ohm's Law, I = V/R, where voltage remains constant. For an ideal constant voltage source, the internal resistance is zero, allowing maximum current draw without voltage drop. In contrast, a real constant voltage source has internal resistance, which causes a voltage drop when current flows, limiting the maximum current available. As resistance approaches zero in a real source, the current draw increases until it is limited by the internal resistance. Understanding these differences is crucial for analyzing circuit behavior in electrical engineering.
greatest
Messages
11
Reaction score
0
Hey guys

I am new to Electrical Eng, i got a question to answer, it says that a variable resistor is connected to a " Constant Voltage Source", how does the current through the resistor changes as its resistance varies from zero to infinity?

I also need with the same question, but with a ideal constant Voltage source and real constant vol source!

Thanks
 
Engineering news on Phys.org
Do you know Ohms Law? If so, see how the current is related to voltage and resistance. Remember, the voltage is constant.
 
Yeh V = R*I, Since for the first V = Constant, Then I = V/R, I = 1/r, but what is the difference between ideal, real, and voltage constant sources!,

thanks
 
There are many subtle differences, and one big one. What happens to the current draw from an ideal source as the load resistance goes to zero? Would you expect the same behavior from a real source?
 
Can u give me some definitions for ideal and real sources and how the ohm's law works with those! And how resistance affects the current in those sources.

thanks and sorry really new with circuits and all!
 
Real voltage sources have an internal resistance - draw it as a battery with a small resistor in series. Now image you have a 12V battery with an internalal resistance of 1Ohm, as you draw 1Amp from the battery there is a 1V drop across the internal resistor and so you only get 11V out. What's the maximum current you can draw from such a battery?
AN ideal source has a zero Ohm internal resistance.
 
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
Back
Top