How to Cool 70°C Water to 35-38°C?

  • Thread starter Thread starter Vig16
  • Start date Start date
  • Tags Tags
    Cold Water
AI Thread Summary
To cool 70°C water to a target temperature of 35-38°C while achieving a total of 8 ounces, a simple ratio calculation can be used. The discussion highlights that mixing 4 ounces of 70°C water with 4 ounces of water at 20-25°C results in temperatures around 41-46°C, indicating that the cooling method needs adjustment. To reach the desired temperature, water at approximately 3-4°C is suggested for mixing. The importance of assuming no heat loss and ensuring thorough mixing is emphasized for accurate results. This straightforward calculation simplifies the process of achieving the desired water temperature.
Vig16
Messages
7
Reaction score
0
I have a question about how to cool the water that's already in my cup. I already have 3-4 ounces of 70°C water in my cup and want to bring that overall temperature down to 35-38°C. The end solution needs to have 8 ounces of water. I already tried doing this with room temperature water (20-25°C) and the end solution came out to be 41°C and 46°C in my two trials.

Is there a certain formula I can use to calculate the temperature needed to cool the 70°C water down to my desired range?
 
Engineering news on Phys.org
Hi,

Is it as simple as a ratio , assuming there is no heat loss to the surroundings through the process and that the water is well mixed

if you have

4 ounces at 70
4 ounces at 20
you'll have 8 ounces at 45

by that logic you'd need water at about 3-4 degrees
 
Maxong091 said:
Hi,

Is it as simple as a ratio , assuming there is no heat loss to the surroundings through the process and that the water is well mixed

if you have

4 ounces at 70
4 ounces at 20
you'll have 8 ounces at 45

by that logic you'd need water at about 3-4 degrees

Great! Thank you! I knew it had to be a simple calculation, but didn't even think it'd be that simple!
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top