How to determine fracture toughness Kic from a punch test?

Thread starter IB7899
Start date Apr 25, 2015
Tags

Fracture Fracture mechanics Test

AI Thread Summary

To determine fracture toughness (Kic) for aluminum using a punch test, the load-displacement curve and specimen dimensions are essential. While formulas for brittle materials are available, specific equations for ductile materials like aluminum are less common. The discussion highlights the need for a reliable method to adapt existing formulas or derive new ones suitable for ductile behavior. Participants are encouraged to share insights or references that could assist in this calculation. Understanding the differences in material properties is crucial for accurate fracture toughness assessment.

Apr 25, 2015

IB7899

I am looking to determine fracture toughness for aluminium, from a punch test. I have the dimensions of the specimen and the load-displacement curve of the test. I have seen how to calculate Kic for brittle materials from a punch test but am struggling to find a formula for ductile materials such as aluminium.

thanks

Engineering news on Phys.org

Apr 26, 2015

IB7899

anyone please?

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...

View full post »

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...

View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly

View full post »