Hydraulic Engine: Ball Spin, Stop & Why?

  • Thread starter Thread starter adska
  • Start date Start date
  • Tags Tags
    Engine Hydraulic
AI Thread Summary
The discussion centers on the behavior of a metal ball in a hydraulic engine scenario. If the ball, air, and oil are stationary, it will not spontaneously spin. Air pressure can cause the ball to spin when forced through a valve, but it will eventually stop due to viscous drag forces. Concerns are raised about the pressure balance in the sealed container, questioning why air would move past the ball. The conversation emphasizes the principles of physics governing motion and the importance of adhering to forum rules against discussing perpetual motion.
adska
Messages
2
Reaction score
0
What will happen with metal ball in the below picture? it will spin? if yes, when it will stop and why? I am not very faimiliar with physics, but I am sure that ball must spin :D

http://www.cagof.com/Untitled.png
 
Last edited by a moderator:
Science news on Phys.org
If the ball, air, and oil are all initially stationary then it will not suddenly start to spin.

Please be aware of the forum rules prohibiting discussion of perpetual motion machines.
 
Dale said:
If the ball, air, and oil are all initially stationary then it will not suddenly start to spin.

Please be aware of the forum rules prohibiting discussion of perpetual motion machines.

air will be pressed through valve
 
Then it could start spinning. It would stop spinning when viscous drag forces stop it.
 
The container appears sealed at the bottom so the pressure in the oil is likely to be the same/similar to that of the air - so why would the air go past the ball?
 

Thread 'Condensate rate of water for an air conditioning cooling coil'

I need to calculate the amount of water condensed from a DX cooling coil per hour given the size of the expansion coil (the total condensing surface area), the incoming air temperature, the amount of air flow from the fan, the BTU capacity of the compressor and the incoming air humidity. There are lots of condenser calculators around but they all need the air flow and incoming and outgoing humidity and then give a total volume of condensed water but I need more than that. The size of the...
View full post »
Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'

Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'

Let's say we have a cylinder of volume V1 with a frictionless movable piston and some gas trapped inside with pressure P1 and temperature T1. On top of the piston lay some small pebbles that add weight and essentially create the pressure P1. Also the system is inside a reservoir of water that keeps its temperature constant at T1. The system is in equilibrium at V1, P1, T1. Now let's say i put another very small pebble on top of the piston (0,00001kg) and after some seconds the system...
View full post »

Similar threads

I Question about an interesting experiment video (two magnetic balls in tubes)
Replies
5
Views
1K
I Why does the end of the fracture have a branch? (Fracking)
Replies
2
Views
922
B Roulette wheel physics and probability
Replies
9
Views
5K
Pool Ball Physics: Questions on Impact Spins
Replies
5
Views
3K
PID tuning of hydraulic drives with high inertia
Replies
9
Views
3K
I Effects on Engine Overheating and Pressure Dynamics
Replies
4
Views
2K
Torque requirements for launching a soccer ball
Replies
4
Views
3K
Thermodynamics of a cannon ball / musket ball shot bullet
Replies
29
Views
5K
Reverse engineering potential and kinetic energy
Replies
3
Views
2K
B The physics of flywheel launchers (like tennis ball shooters)
2
Replies
60
Views
4K

Hot Threads

Recent Insights

Back
Top