Understanding Kirchoff's Law in A/C: Application and Explanation"

  • Thread starter Thread starter prasanaharani
  • Start date Start date
  • Tags Tags
    Kirchoff Law
AI Thread Summary
Kirchoff's Law is applicable in AC circuits when using impedance and reactance. The relationship is defined by the equation V=I|Z|, where Z is the total impedance calculated as |Z|=√(R²+χ²). The reactance χ is the difference between inductive and capacitive reactance, represented as χ=χ_L-χ_C, with χ_L and χ_C defined by their respective formulas. For accurate analysis, voltages and currents should be expressed in complex form, ensuring all values are at the same frequency. This approach allows for effective application of Kirchoff's Law in AC circuit analysis.
prasanaharani
Messages
9
Reaction score
0
Whether Kirchoff's Law Is Applicable In A/c.then Say How?
 
Engineering news on Phys.org
Whether Kirchoff's Law Is Applicable In A/c.then Say How
 
prasanaharani said:
Whether Kirchoff's Law Is Applicable In A/c.then Say How

using impedance/reactance

V=I|Z|

where Z is

|Z|=\sqrt{R^2+ \chi ^2}

where \chi is

\chi = \chi _L - \chi _C

where \chi _L and \chi _C are

\chi _L=2 \pi f L and \chi _c= \frac{1}{2 \pi f C}

note: these equations only give you maximum or rms voltage or current

for instantaneous use these, which if you don't know, are sinusoidal functions

\tilde{V} = V_0e^{i(\omega t + \phi_V)}

and

\tilde{I} = I_0e^{i(\omega t + \phi_I)}

\omega = 2 \pi f and tan( \phi ) = \frac{ \chi}{R}
 
Last edited:
It is very much applicable. The catch is that you should have them in complex form (phase and magnitude) and all listed currents and voltage must be of the same frequency.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Back
Top