Momentum & Energy: 10kg Block Hit by 300m/s Bullet

2RIP
Messages
62
Reaction score
0

Homework Statement


The non-moving 10-kg block is held frictionlessly inclined at 30 degrees by a stop at point A . A 0.010-kg bullet is moving at 300 m/s hits the block and embeds into it.

http://img386.imageshack.us/img386/9305/68906392wf8.jpg

I'm unsure which is the horizontal velocity.

Homework Equations


m1v1=m2v2

The Attempt at a Solution


Let m=0.01 kg, M=10 kg, v=300 m/s

mv=(m+M)v_{f}
v_{f}=(mv)/(M+m) = 0.3 m/s<br />

I thought the final velocity would be the initial horizontal velocity of the two combined masses, however, the solution says the horizontal velocity is vf*cos30=0.26 m/s and implies the velocity up the incline plane as v=0.3 m/s. Don't we need to be consistent with the direction of velocity in the momentum equation?

It kind of makes sense to me because if vx=0.3 m/s, then the inclined velocity would be greater than 0.3 m/s. But equation wise, I can't figure out how it happened.

Thanks
 
Last edited by a moderator:
Physics news on Phys.org
The horizontal velocity of the combined mass immediately before it interacts with the inclined plane is the final velocity you found by momentum conservation. But it's likely you must find the horizontal velocity due to the plane.

To do this you must decompose the final velocity into its components parallel and perpendicular to the inclined plane. If you think about where the perpendicular component is directed, you will see that you're just left with the parallel part. This is the initial velocity of the combined mass along the plane that you must decompose further into its horizontal, and vertical, component.

Having said all that though, my calculations disagree with the solution you have but I don't see what I'm doing wrongly.
 
To solve this, I first used the units to work out that a= m* a/m, i.e. t=z/λ. This would allow you to determine the time duration within an interval section by section and then add this to the previous ones to obtain the age of the respective layer. However, this would require a constant thickness per year for each interval. However, since this is most likely not the case, my next consideration was that the age must be the integral of a 1/λ(z) function, which I cannot model.
Back
Top