What Are the Highest and Lowest Temperatures in Injection Moulding?

  • Thread starter Thread starter matejbond
  • Start date Start date
  • Tags Tags
    Cooling Law
AI Thread Summary
The discussion focuses on calculating the highest and lowest temperatures during the injection moulding process for four different material inserts. The user seeks assistance in defining temperature curves over a 22-second cycle where molten plastic is injected and then ejected. Previous calculations yielded unexpectedly high results, prompting a request for guidance. The forum emphasizes that while members can assist with problem-solving, private consultations are not allowed. Overall, the user is looking for collaborative input to refine their temperature calculations.
matejbond
Messages
1
Reaction score
0
Hi everyone I am looking for someone who could possibly help me with my calculations regarding injection moulding. Basically I have four different inserts (from four different materials). Into these inserts the molten plastic is injected, where stays for about 22 seconds and then is ejected, then the cycle repeats. I am trying to define what will be the highest and lowest temperature during these cycles, basically I need to calculate and define the process of temperatures(curves) T on the t.

If anyone would know and will be able to spend some time I would really appreciate it. I will then provide you with all information I know. I already calculated (with help of my friend) this issue but results were really high.
Please looking for any help.

thanks
 
Physics news on Phys.org
At Physics Forums, we can help members solve their problems themselves, but private consultation is not permitted.
 

Thread 'Is calling fictitious forces "not real" just about terminology?'

Hi there, im studying nanoscience at the university in Basel. Today I looked at the topic of intertial and non-inertial reference frames and the existence of fictitious forces. I understand that you call forces real in physics if they appear in interplay. Meaning that a force is real when there is the "actio" partner to the "reactio" partner. If this condition is not satisfied the force is not real. I also understand that if you specifically look at non-inertial reference frames you can...
View full post »

Thread 'Derivation of Hamilton's Principle: Questions'

I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
View full post »

Similar threads

What is the approximate pressure at the center of a cool Earth with no gravity?
Replies
1
Views
2K
What is the temperature loss along a duct with hot air entering?
Replies
24
Views
3K
Efficiency of Stirling Cycle - Is it the same as the Carnot Engine?
Replies
14
Views
1K
Water temperature with two materials cooling it
Replies
7
Views
1K
Cooling a pond with river water?
Replies
3
Views
2K
I have a few questions about refrigeration and AC units
Replies
1
Views
3K
A Can Hamson-Linde cycle liquidize N2?
Replies
7
Views
2K
Application of Newton's law of cooling to biophysics experiment
Replies
3
Views
3K
Applying Newton's cooling equation to a pipe cooling
Replies
1
Views
6K
Heat transfer problem for cooling a solar panel
Replies
9
Views
3K

Hot Threads

Recent Insights

Back
Top