Optimizing Airflow for Efficient Fridge Cooling: A Scientific Approach

AI Thread Summary
The discussion revolves around creating a fridge that utilizes cold outside air instead of an electrical compressor, focusing on optimizing airflow for efficient cooling. Key variables include pipe dimensions, fan speed, and temperature differences between the outside and inside of the fridge. Participants debate the necessity of calculating fan run time versus using a thermostat for temperature control. There are concerns about the practicality of the idea, particularly regarding extreme cold temperatures that may hinder efficiency. Ultimately, the goal is to model the system for energy efficiency, particularly in regions with prolonged cold weather.
cxo
Messages
3
Reaction score
0
The problem is as follows, my friend and I want to make a fridge that uses cold air from outside, instead of an electrical compressor. We plan to simply use a fan, and pipe to bring cold air from outside into the fridge.

So if our variables are:

- Pipe length / Diameter
- Fan speed / CFM
- Wind temperature outside
- Temperature inside the fridge
- Desired temperature to reach inside the fridge
- Heat capacity of fridge contents
- Volume of fridge / Volume of contents

How do we calculate, how long the fan needs to run, at what CFM to bring the temperature in the fridge from its current temperature down to the desired temperature in a particular amount of time?

Assuming the outside temperature is always below the desired temperature.

Thanks.
 
Engineering news on Phys.org
Welcome to PF. I'm not sure why you would care to measure how long the fan has to run. Why does it matter? You use a thermostat to control the temp and the fan goes on and off as necessary.
 
Yes, the end result would eventually be something like that. Moreover we'd like to have finer grained control over the cooling process, than just ON|OFF of the fan, ie adjust the RPM etc..

We would like to model the system on a computer before implementing it. Basically to determine the amount of energy needed to maintain the fridge temperature. It's meant to be an energy efficient solution, and I'd like to prove it using a computer model.
 
""Assuming the outside temperature is always below the desired temperature.""

It won't be. If you do live in a very cold place it is going to be too cold a lot of the time. Bit of a.. daft idea..sorry to say.
 
Pumblechook said:
""Assuming the outside temperature is always below the desired temperature.""

It won't be. If you do live in a very cold place it is going to be too cold a lot of the time. Bit of a.. daft idea..sorry to say.

How does this help the thread?

And actually the city I live in, the temperature outside is below -20degC over 5months in a year.
 
Just move the fridge to a cold part of the house then.. Outbuilding. Zero electricity use for a good part of the year.
 
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top