Optimizing Earthing Rods for 132kV Switch Yard: The Right Number and Length

  • Thread starter Thread starter neduet
  • Start date Start date
  • Tags Tags
    Earthing
AI Thread Summary
For a 132kV switch yard, the optimal number of earthing rods should ensure they are spaced at least the length of the rods apart, typically around 10 feet, to prevent electromagnetic interference. The length of the rods is specified at 3000mm. It's advised to consult local electrical regulations for proper installation guidelines rather than relying solely on forum discussions. Professional consultation is recommended for precise requirements. Proper earthing is crucial for safety and system efficiency.
neduet
Messages
64
Reaction score
0
Hi ,

friends , how many earthing rods we should use in 132 kv switch yard. grid/mesh earthing system. less number better or should we use as many as we can. ? rods length is 3000mm ?

thanks.
 
Engineering news on Phys.org
For maximum efficiency, rods should be placed no closer together than the length of the rod. Normally, this is 10 ft. Each rod forms an electromagnetic shell around it, and when the rods are too close, the shells actually interfere with each other.

Eleven Practical tips for grounding substations
 
neduet said:
Hi ,

friends , how many earthing rods we should use in 132 kv switch yard. grid/mesh earthing system. less number better or should we use as many as we can. ? rods length is 3000mm ?

thanks.

You should not be asking these sorts of questions on a forum
you should instead consulting the electrical regulations on the construction and installation of such in your countryRegards
Dave
 
  • Like
Likes Babadag
Agreed. Thank you Dave. :smile:
 
  • Like
Likes Babadag and davenn
neduet said:
Hi ,

friends , how many earthing rods we should use in 132 kv switch yard. grid/mesh earthing system. less number better or should we use as many as we can. ? rods length is 3000mm ?

thanks.

If you do not know the answer to this, perhaps consult a professional...
 
Thread 'Weird near-field phenomenon I get in my EM simulation'
I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
Hello dear reader, a brief introduction: Some 4 years ago someone started developing health related issues, apparently due to exposure to RF & ELF related frequencies and/or fields (Magnetic). This is currently becoming known as EHS. (Electromagnetic hypersensitivity is a claimed sensitivity to electromagnetic fields, to which adverse symptoms are attributed.) She experiences a deep burning sensation throughout her entire body, leaving her in pain and exhausted after a pulse has occurred...
Back
Top