Photodetector vs. Photosensor: Infrared Light & Point Source

AI Thread Summary
A photodetector and a photosensor can be considered similar, but their definitions may vary based on context. A point source refers to a radiation source that emits light from a single, localized point, and the intensity of light from such a source diminishes inversely with the square of the distance from it. Infrared light can be detected using specialized detectors designed for specific regions of the electromagnetic spectrum. The discussion also touches on the symbols used for infrared sources and detectors, although specific symbols were not provided. Understanding these concepts is crucial for applications involving infrared light detection.
Alvin
Messages
6
Reaction score
0
Help! is a photo detector the same as photosensor? can they be specifically for infrared light? and what does point source mean?
 
Engineering news on Phys.org
Well point source means exactly that. A point-like source of radiation. I'd say they are the same, but it might depend on the context. And yeah, you can usually get a detector specifically for your region of interest in the em spectrum.
 
so does point sourc light spread out? so that the intensity is inversly proportional to the square of the distance from source?
 
please could you tell me what is the symbol for a infrared source and detector?

thanks
Adam
 
Alvin said:
so does point sourc light spread out? so that the intensity is inversly proportional to the square of the distance from source?

yes that's right.
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
Thread 'How can I find the cleanout for my building drain?'
I am a long distance truck driver, but I recently completed a plumbing program with Stratford Career Institute. In the chapter of my textbook Repairing DWV Systems, the author says that if there is a clog in the building drain, one can clear out the clog by using a snake augur or maybe some other type of tool into the cleanout for the building drain. The author said that the cleanout for the building drain is usually near the stack. I live in a duplex townhouse. Just out of curiosity, I...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top