Question on work,energy and power

  • Thread starter Thread starter matsci0000
  • Start date Start date
  • Tags Tags
    Power
AI Thread Summary
The discussion revolves around calculating the work required to pull a hanging portion of a uniform chain onto a table. The initial calculation of work done was based on the weight of the hanging part, leading to an incorrect answer of mgL/16. The correct answer is mgL/32, which accounts for the distribution of mass and the center of mass concept. The center of mass plays a crucial role, as it allows for a more accurate average displacement of the hanging chain, resulting in less work required. Understanding the center of mass simplifies the calculation and leads to the correct solution.
matsci0000
Messages
3
Reaction score
0
Que- A uniform chain of length L and mass m is held on a smooth table with one-fourth of its length hanging over the edge. If g is the acceleration due to gravity, find the work required to pull the hanging part on the table.


CHECK MY SOLUTION---------AND POINT OUT MY MISTAKE.

Weight of the hanging part of the chain=mg/4

Therefore, work done=(mg/4)(L/4)
=mgL/16...Answer


I am getting this answer. But the correct answer is mgL/32.
Is there any role of center of mass in this question?:confused:
 
Physics news on Phys.org
This is because the mg/4 isn't all concentrated at L/4 distance from the table. It requires less work because some of that mass is distributed closer to L/4 distance to the table. Intuitively, you can see that the total work should be half of what you computed since then, the "average" displacement of the chain (taking into account the mass distribution) is only L/8 away from the table. Mathematically, you need to compute this differently.
 


matsci0000 said:
Therefore, work done=(mg/4)(L/4)
Hint: Are all parts of the hanging piece raised by the same distance?

Is there any role of center of mass in this question?
Sure. Using the center of mass will allow you to get the answer quicker.

Moderator's Note: Multiple threads merged.
 
Last edited:
What is the significance of center of mass in this question?
 
You can use the center of mass as an average for all the work done. Less work is done at the top of the chain than the bottom of the chain. It will all even out if you just look at the center of the chain, that is the center of the hanging part of the chain.
 
TL;DR Summary: I came across this question from a Sri Lankan A-level textbook. Question - An ice cube with a length of 10 cm is immersed in water at 0 °C. An observer observes the ice cube from the water, and it seems to be 7.75 cm long. If the refractive index of water is 4/3, find the height of the ice cube immersed in the water. I could not understand how the apparent height of the ice cube in the water depends on the height of the ice cube immersed in the water. Does anyone have an...
Thread 'Variable mass system : water sprayed into a moving container'
Starting with the mass considerations #m(t)# is mass of water #M_{c}# mass of container and #M(t)# mass of total system $$M(t) = M_{C} + m(t)$$ $$\Rightarrow \frac{dM(t)}{dt} = \frac{dm(t)}{dt}$$ $$P_i = Mv + u \, dm$$ $$P_f = (M + dm)(v + dv)$$ $$\Delta P = M \, dv + (v - u) \, dm$$ $$F = \frac{dP}{dt} = M \frac{dv}{dt} + (v - u) \frac{dm}{dt}$$ $$F = u \frac{dm}{dt} = \rho A u^2$$ from conservation of momentum , the cannon recoils with the same force which it applies. $$\quad \frac{dm}{dt}...
Back
Top