Recommended Electrical Engineering Books

AI Thread Summary
Recommended books for Electrical Engineering include titles focused on Analog Circuit Design, RF Circuits, Microelectronics, Power Electronics, and Signals and Systems, emphasizing feedback and control theory. Participants highlight the importance of having foundational texts in these areas for both students and professionals. Specific book recommendations are sought to enhance understanding and practical skills in these topics. The discussion underscores the value of quality resources in advancing knowledge in Electrical Engineering. Every Electrical Engineer should consider adding these essential books to their collection.
6eecs
Messages
19
Reaction score
0
Does anyone have a good suggestion for books in Electrical engineering, specifically:

- Analog Circuits Design and Analysis
- RF circuits
- Microelectronics and Device physics
- Power Electronics
- Signals and Systems; Feedback and control theory for Electrical Engineering.

Something short and to the point would be very appreciated (I don't have much time)

Thank you.
 
Engineering news on Phys.org

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
View full post »
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Similar threads

I need to interview an electrical engineer (School related)
Replies
1
Views
3K
Baseload Power
Replies
31
Views
2K
What is Baseband RF communication?
Replies
5
Views
1K
Computer Programs to help design circuits to hook up to a Raspberry Pi
Replies
3
Views
2K
Self excited induction generators and grid connected solar inverters?
Replies
9
Views
2K
Permanent Magnet Motors & Koenigsegg’s ‘Dark Matter’ Electric Motor
Replies
0
Views
2K
EE - Project Eradicating Bacteria/Biofilm
Replies
18
Views
2K
How can I reroute multiple signals from a 4 pin connector using a relay switch?
Replies
37
Views
6K
Engineering Electric Power Systems book recommendation
Replies
3
Views
3K
Electric cars -- Does periodic coasting help efficiency?
Replies
18
Views
2K

Hot Threads

Recent Insights

Back
Top