Shear lines from a FBD with distributed forces

4 replies · 2K views · last reply
Finn072
Messages
3
Reaction score
0
Homework Statement
Formulate both the V and M diagrams for the following FBD.
Relevant Equations
How would I go about this? I've looked everywhere on youtube but couldn't find a single example that used distributed forces.
, this is the FBD in question
 
Lnewqban said:
Welcome!
I still can’t see the posted image.
Hey thanks! this should work:
I'll also add my attempt at the 4 V(m) lines and the resultant graph (which isn't correct, I do know that much)
 
Attachments
  • Four free-body diagrams of a beam with distributed loads labelled shear one through shear four, each with shear equations written beneath, showing the sum of forces in y and V(x) expressions.
    shears.png
    30.7 KB · Views: 152
  • Free-body diagram of a beam with segments 1.85 m, 4.00 m, 5.80 m, 3.75 m and 0.75 m, with distributed loads 13.13 kN/M, 14.56 kN/M, 10.3 kN/M and 5.55 kN/M, a fixed-end moment Ma = 1092.01 kN*M, reaction Ay = 153.602 kN and a downward point load of 26.156 kN.
    fbd.jpg
    17.1 KB · Views: 177
Could you post the text of the problem?
It seems to be the load distribution on the half-wing of an airliner.
 
Lnewqban said:
Could you post the text of the problem?
It seems to be the load distribution on the half-wing of an airliner.
"Determine the functions for the Shear and Moment (“V & M”) lines and put these functions in a table. Choose x=0 at the wingtip, then start working from the wingtip to the wing root. Consequently use the right section of a separation. Create a complete FBD for each required separation."

My teacher mentioned during a lesson that working from tip to root was not mandatory, since the opposite is easier (apparently)