Should I add an intercooler and EGR to my turbocharged gas engine?

  • Thread starter Thread starter autoingenes
  • Start date Start date
  • Tags Tags
    Engines Gas
AI Thread Summary
Adding an intercooler to a turbocharged natural gas engine may not significantly improve volumetric efficiency, as its primary function is to reduce the temperature of compressed air, enhancing air density and preventing excessive combustion temperatures. EGR systems can help lower combustion temperatures and emissions, but their effectiveness in increasing octane rating is questionable since natural gas already has a high octane rating. The discussion highlights the rarity of resources on turbocharging natural gas engines, making research challenging. Overall, the decision to add an intercooler or EGR should consider these factors and the specific goals for engine performance and emissions. Further research and data on their effects in turbocharged spark-ignition engines would be beneficial.
autoingenes
Messages
1
Reaction score
0
Hey Guys needed some advice related to Turbocharging of natural gas engines.
I'm working on turbocharging of gas engine for the first time and was trying to do some research on the same before jumping into the nitty gritty stuff. I Do not have much experience working with turbochargers. Turbo natural gas engine are very rare and its difficult to find any helpful material either.

I know that turbocharged diesel engines generally include intercoolers to further increase the volumetric efficiency. Since Natural gas engine have lower volumetric efficiency, will adding an intercooler have a quantifiable improvement on increasing the volumetric efficiency?

Also what are the pro and cons of adding an EGR to the mix?

Any links/papers describing the effect (good or bad) of adding an intercooler and/or EGR to a turbocharged SI engine will go a long way in helping me make up my mind.
 
Engineering news on Phys.org
Intercoolers are not there to improve the volumetric efficiency, per se. They are there to reduce the temperature of the compressed air to improve the air density and because charging the cylinders with heated air can produce excessive combustion temps and high EGTs.

EGR systems are there to make the gas behave like it has a higher octane rating and to reduce combustion temps in order to reduce pollution. Natural gas already has a very high octane rating, so it's questionable whether adding EGR would do much for octane. Not sure about the pollution part.
 
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
Back
Top