Solving Transistor Doubts with ADS: 2SD2216 from Panasonic

  • Thread starter Thread starter spid3rx
  • Start date Start date
  • Tags Tags
    Doubts Transistor
AI Thread Summary
The discussion centers on simulating a circuit involving the Panasonic 2SD2216 transistor in ADS software, specifically for audio signal amplification. The user is facing challenges due to the absence of the 2SD2216 model in the ADS library and is currently using a Q2N2222 transistor as a substitute by adjusting its Hfe value. There is uncertainty about the appropriateness of this substitution, as the 2SD2216 is a darlington transistor, unlike the Q2N2222. The user seeks guidance on whether other transistor models can be used with modified Hfe values and how to create a custom transistor model in ADS. Accurate modeling is crucial for effective circuit simulation and performance analysis.
spid3rx
Messages
15
Reaction score
0
Hello all,

I have been trying to simulate a circuitry involving a transistor for the microphone line. I believe it was used for amplication of the external audio signal (not too sure, maybe can share the circuit). I am using the ADS to simulate my circuit.

The problem I faced was the transistor model was not in my ADS library and the information I got now is the spec. The transistor is a BJT silicon NPN epitaxial planer type with Hfe = 210 - 340 gain. The p/n is 2SD2216 from panasonic.

I was using Q2N2222 transistor as a replacement by changing the Hfe value and I'm not sure whether I am doing the right thing.

My questions are
whether I can used other transistor model and change the Hfe to represent it?
How do I create my own transistor model in ADS software?

thanks in advance!
 

Attachments

Last edited:
Engineering news on Phys.org
Sorry, there was a typo there. I was a 2SD2216 transistor.
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

Similar threads

Replies
2
Views
2K
Replies
7
Views
7K
Replies
1
Views
5K
Replies
1
Views
1K
Replies
5
Views
5K
Replies
13
Views
4K
Replies
11
Views
6K
Replies
10
Views
3K
Back
Top