Sources for resistivity of W depending on temperature

AI Thread Summary
The discussion revolves around finding accurate temperature-resistivity data for Tungsten between 300 and 2500 K for an experiment involving a W bulb. The CRC handbook's tables are deemed insufficient due to limited data points and poor correlation across editions. A user suggests a link to a relevant paper that may contain the needed information. The request for assistance highlights the importance of precise data for experimental accuracy. Accessing reliable resources is crucial for successful experimentation in this temperature range.
Zoroaster
Messages
10
Reaction score
0
Hello everyone

I am trying to do an experiment involving a W bulb, in which I am completely dependent of knowing the temperature-resistivity relation of Tungsten in the temperature range 300 - 2500 K. The CRC handbook has some tables, but they have few data points and correlate poorly with each other (in different editions). Does anyone here know where else I can find a good table (or formula, although a linear relation is not precise enough)?

Any help would be much appreciated!

-Zoroaster
 
Science news on Phys.org
Thanks!
 

Thread 'Condensate rate of water for an air conditioning cooling coil'

I need to calculate the amount of water condensed from a DX cooling coil per hour given the size of the expansion coil (the total condensing surface area), the incoming air temperature, the amount of air flow from the fan, the BTU capacity of the compressor and the incoming air humidity. There are lots of condenser calculators around but they all need the air flow and incoming and outgoing humidity and then give a total volume of condensed water but I need more than that. The size of the...
View full post »

Thread 'Entropy and configurations of microstates'

I was watching a Khan Academy video on entropy called: Reconciling thermodynamic and state definitions of entropy. So in the video it says: Let's say I have a container. And in that container, I have gas particles and they're bouncing around like gas particles tend to do, creating some pressure on the container of a certain volume. And let's say I have n particles. Now, each of these particles could be in x different states. Now, if each of them can be in x different states, how many total...
View full post »
Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'

Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'

Let's say we have a cylinder of volume V1 with a frictionless movable piston and some gas trapped inside with pressure P1 and temperature T1. On top of the piston lay some small pebbles that add weight and essentially create the pressure P1. Also the system is inside a reservoir of water that keeps its temperature constant at T1. The system is in equilibrium at V1, P1, T1. Now let's say i put another very small pebble on top of the piston (0,00001kg) and after some seconds the system...
View full post »

Similar threads

Help with light bulb radiation
Replies
1
Views
1K
Incandescent Bulb - suitable approximation for voltage-current curve
Replies
2
Views
897
B Infrared Detectors & The 2nd Law of Thermodynamics
4
Replies
152
Views
9K
Resistance, capacitance, inductance of a real wire
Replies
2
Views
2K
Correlating albedo with temperature?
Replies
6
Views
3K
Voltage vs Resistance. (Temperature analogy for metals)
Replies
4
Views
2K
Resistance of a bulb 100 W, 230 V
Replies
16
Views
8K
I Why is the emissivity of metals low?
Replies
17
Views
3K
Two-Phase Pressure Drop (I need an expert)
Replies
0
Views
1K
Pressure required for water discharge
Replies
17
Views
2K

Hot Threads

Recent Insights

Back
Top