Twinax Theory: How Does Twinax Work?

  • Thread starter Thread starter HPRF
  • Start date Start date
  • Tags Tags
    Work
AI Thread Summary
Twinax technology involves two coaxial conductors that work together to enhance signal integrity and reduce interference. The discussion seeks resources that explain the theoretical framework behind twinax, particularly focusing on the equivalent circuits and interactions between the two coaxial elements. Participants express a need for detailed theoretical insights and references, as existing literature appears limited. Understanding these interactions is crucial for applying twinax properties to similar devices. Comprehensive resources on twinax theory would greatly benefit those exploring its applications.
HPRF
Messages
31
Reaction score
0
Hi,

I am investigating a device that I think shows similar properties to twinax, but I am unable to find any theory on it.

Does anyone know of any websites or books that explain the theory behind twinax; equivalent circuits of twinax would be especially helpful...

Thanks in advance,

Daniel
 
Last edited:
Engineering news on Phys.org
Hi,

I don't think the previous message was clear enough.

What I am looking for is theory that describes the interaction between the the two individual coax's in twinax.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

How Does Project 122 Snap Circuit AM Transmitter Work?
Replies
35
Views
5K
How does AM broadcasting/receiving work + a project for HS students?
Replies
20
Views
1K
How does a Permanent capacitor motor actually work?
Replies
7
Views
1K
How do pull up and pull down resistors remove electrical noise?
Replies
46
Views
10K
Getting a High Speed Synchronous N-Channel MOSFET Driver working right
Replies
39
Views
5K
US Split-Phase to EU Heat Pump Not Working
Replies
1
Views
2K
Good LED bulb will not work in a socket
Replies
21
Views
2K
Theory question about neutrals in circuits
Replies
32
Views
3K
Why Does Amplitude Not Matter in Positive Sequence Detector Circuits?
Replies
1
Views
2K
Amateur Physicist Making a New Theory
Replies
8
Views
517

Hot Threads

Recent Insights

Back
Top