Velocity of bowling ball after the collision

AI Thread Summary
The discussion focuses on calculating the velocity of a bowling ball after a collision with a pin, using the principle of conservation of momentum. The initial momentum of the system, which includes the bowling ball and the pin, must equal the final momentum after the collision. The formula presented is MV = mv + Mx, where M is the mass of the bowling ball, m is the mass of the pin, V is the initial velocity of the bowling ball, and x is the final velocity of the bowling ball. Participants emphasize the importance of substituting the correct values and maintaining proper units throughout the calculation. Understanding these concepts is crucial for solving the problem accurately.
MorallyObtuse
Messages
45
Reaction score
0
Hi,

I just need this explained, please.

Homework Statement



A large bowling ball of mass 6.0 kg moving with a velocity 3.0ms-1 has ahead on collision with a single pin of mass 0.50 kg.If the pin moves with a velocity of 4.0ms-1,calculate the velocity of bowling ball after the collision.
 
Physics news on Phys.org
Are you familiar with conservation of momentum?
Momentum is mass times velocity.
The momentum of the system before hand equal the momentum of the system after the collision.

Try some equations with it.
 
Redd is absolutelly right:

The law of conservation of momentym states that:

Initial Momentum=Final Momentum

if M=mass of bowl and m=mass of pin, V=velovity of bowl and v=final velocity of pin then:

MV=mv+Mx where: x=final velovity of bowl.

Substitute values to get x.
Remember about units,
good luck.
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top