What is the Flywheel Inertia and Mass of the Mercedes Benz C220 CDI Engine?

AI Thread Summary
The discussion centers on the need for specific technical information regarding the flywheel inertia and mass of the Mercedes Benz C220 CDI engine. The original poster is seeking data that is difficult to find, particularly the flywheel and crankshaft specifications. Participants suggest obtaining this information from the engine manufacturer's data sheet. There is an emphasis on contacting the manufacturer directly for accurate details. Accessing the manufacturer's data is crucial for the project on internal combustion engines.
chhitiz
Messages
221
Reaction score
0
i have been working on this project on internal combustion engines and i need some info. that i am finding hard to get. i need to know the mass and inertia of the flywheel and crankshaft of the Mercedes Benz c220 cdi engine.or any diesel engine successfully being used today. can anyone help me?
 
Engineering news on Phys.org
Sure, just ask for a copy of the engine manufacturer's data sheet.
 
where do i get engine manufacturer's data sheet?
 
The engine manufacturer would be a good start.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'What's the most likely cause for this carbon seal crack?'

Thread 'What's the most likely cause for this carbon seal crack?'

We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...
View full post »

Similar threads

Automotive Motorcycle: Flywheel mass and rear wheel torque
Replies
3
Views
3K
Flywheel design. Inertia dyno for 745 KW engine.
Replies
2
Views
4K
Can a Rotary Engine Efficiently Charge Batteries in Hybrid Vehicles?
Replies
7
Views
2K
How can a flywheel increase torque in a generator system?
Replies
15
Views
7K
Determining Mass of Moment of Inertia for Flywheel in IC Engine
Replies
4
Views
5K
I How to transfer angular momentum between two flywheels?
Replies
8
Views
3K
Can a Flywheel Store 1 MW of Power for 50 Seconds with Only 33% Energy Loss?
Replies
1
Views
2K
Why does the clutch disc disengages the flywheel?
Replies
14
Views
11K
Can You Subtract Moments of Inertia to Find the MOI of Unknown Sections?
Replies
1
Views
1K
Automotive Topology optimization of an engine's cylinder block
Replies
14
Views
773

Hot Threads

Recent Insights

Back
Top