Where Does the Normal Line Intersect the Parabola Again?

AI Thread Summary
The discussion focuses on finding the second intersection point of the normal line to the parabola y = -4 - 3x + 4x^2 at the point (1, -3). The user calculated the slope of the tangent line as 5 and derived the normal line's equation as y = -1/5x - 14/5. They then set the normal line equal to the parabola to find the intersection points, identifying x = 1 and x = -3/10 as solutions. The corresponding y-coordinate for x = -3/10 was calculated as y = -137/50. The user seeks confirmation of their calculations and methodology, while a responder questions the necessity of deriving the tangent line.
volc
Messages
6
Reaction score
0
Here is what I found, look at the end to see what my question is:

At what point does the normal line to the graph of y= -4 - 3x + 4x^2 at (1, -3 ) intersect the parabola a second time?

So far I have tried to find the derivative of the parabola which is:

8x-3 (this corresponds to the slope of the tangent line). Therefore now I replaced x by 1 because of the point I am given. This gives:

8(1)-3 = 5

So that is the slope of the tangent line. Now to know the equation of this line I do:

y=5x+b , replace x and y by the point I am given and solve for b.

-3=5(1)+b
b=-8

Thus, the equation is: y=5x-8

The normal is perpendicular to the tangent at (1,-3) so I take the negative reciprocal of the slope to find the slope of the normal:

5 becomes -1/5 (reciprocal). And now I get y=-1/5+b for the normal. Replace x and y by the point (1,-3):

y=-1/5x+b
-3=-1/5x+b
-3=-1/5(1)+b
-14/5=b

The equation for the normal is: y=-1/5x-14/5

Now I want to find when this line and the parabola meet so:

-1/5x-14/5 = -4 - 3x + 4x^2
0 = -6/5 -14/5x + 4x^2
Using (-b+/-sqrt(b^2-4ac))/2a
x1 = 1
x2 = -3/10

x1 = 1 I already know because that is the point where the normal, the tangent, and the parabola intersect. And x2 = -3/10 is the other point where only the parabola and the normal intersect.

To find the y-coordinate of -3/10 I just insert it into the equation and get:

y=-1/5(-3/10)-14/5
y= -137/50

Thus the other point is: (-3/10,-137/50)

I would just like to know if the above calculations are correct and that I am doing the proper steps.

Thanks a lot,

Cedrick O'Shaughnessy
 
Physics news on Phys.org
That all looks good. I'm just not sure why you found the equation for the tangent line, since it doesn't seem like you needed it.
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top