Why is long wave reception better in mountainous areas compared to VHF?

  • Thread starter tushi81
  • Start date
  • Tags
    Wave
In summary: Additionally, higher frequencies rely more and more on line of sight, while at very low frequencies you can propagate out by a surface wave.
  • #1
tushi81
2
0
in mountains part of the country, reception is better on long wave than vhf. why?
 
Physics news on Phys.org
  • #2
The attenuation that a wave experiences in a medium is related the the distance that it has to travel through the medium in terms of its wavelength. The longer the wavelength, the shorter a given depth looks electrically. Assuming that the absorption spectrum is fairly consistent across the general radio frequencies, then we would expect that longer wavelengths would attenuate less over a given distance and set of obstacles.

In addition, the electrical size of a scatterer, the size in wavelengths, also dictates the strength of its perturbation to the wave. A long wavelength signal is going to be much more resistant to scattering off of a given obstacle when compared with a shorter wavelength signal if the material properties do not change drastically.

This means that higher frequencies rely more and more on line of sight as they are affected to a larger degree by buildings, trees, and hills that appear in the way.

At very low frequencies, you can propagate out by a surface wave. This means that the signal is coupled to the surface of the ground. While this is not a very good signal for long distance propagation, it does facilitate reception when not in line of sight since the wave follows the ground and can "dip" down into the valleys. The higher frequencies of TV and FM radio make surface waves less useful. The surface wave will attenuate as it propagates, so the shorter wavelengths again will die out faster than the longer wavelengths of say AM radio. There is the ability for radio to bounce off of the ionosphere and back down to the Earth. This facilitates true long distance propagation, where the signal bounces back and forth between the ionosphere and the Earth. AM can do this on a limited ability, usually best during the night and shortwave is famous for this. FM and TV do not have too much success with this.
 
  • #3
Born2bwire said:
The attenuation that a wave experiences in a medium is related the the distance that it has to travel through the medium in terms of its wavelength. The longer the wavelength, the shorter a given depth looks electrically. Assuming that the absorption spectrum is fairly consistent across the general radio frequencies, then we would expect that longer wavelengths would attenuate less over a given distance and set of obstacles.

In addition, the electrical size of a scatterer, the size in wavelengths, also dictates the strength of its perturbation to the wave. A long wavelength signal is going to be much more resistant to scattering off of a given obstacle when compared with a shorter wavelength signal if the material properties do not change drastically.

This means that higher frequencies rely more and more on line of sight as they are affected to a larger degree by buildings, trees, and hills that appear in the way.

At very low frequencies, you can propagate out by a surface wave. This means that the signal is coupled to the surface of the ground. While this is not a very good signal for long distance propagation, it does facilitate reception when not in line of sight since the wave follows the ground and can "dip" down into the valleys. The higher frequencies of TV and FM radio make surface waves less useful. The surface wave will attenuate as it propagates, so the shorter wavelengths again will die out faster than the longer wavelengths of say AM radio. There is the ability for radio to bounce off of the ionosphere and back down to the Earth. This facilitates true long distance propagation, where the signal bounces back and forth between the ionosphere and the Earth. AM can do this on a limited ability, usually best during the night and shortwave is famous for this. FM and TV do not have too much success with this.

thanks
 
  • #4
you could test this pretty easy right.
just get a wall of concrete or something and a dipole.
then set it to oscillate at various frequencies on one side of the wall.
Then on the other you put a Electromagnetic Radiation Detector and compare the levels for different wavelengths.

this would work right?
 
  • #5
I think the term 'diffraction' could be brought in, here. This describes what happens when a wave is restricted by an obstacle, edge or aperture. The longer wavelengths are diffracted more and tend to 'go round corners' more, whereas the shorted wavelengths are diffracted less and tend to propagate more 'line of sight'. This is in addition to surface absorption effects.
 
  • #6
oh yea, i did not think about that
lambda=v/f
VHF frequench = 30 MHz
wavelength = 10 m

longwave frequency = 30kHz
wavelength = 10000m!
10km! that is huge.

have any diffraction experiments been done with massive wavelengths like this?
 
  • #7
Every field strength survey for radio and TV reception is a diffraction experiment. There are vanloads of such records.
I think that the RF spectrum of solar radiation shows this before and after an eclipse, too.
 

1. Why is long wave radio better for long distance communication?

Long wave radio signals have longer wavelengths, which allows them to travel further distances without losing strength. This makes them ideal for long distance communication, especially in rural or remote areas where other forms of communication may not be available.

2. How does long wave radio compare to other forms of radio communication?

Compared to short wave radio, long wave radio has a lower frequency and longer wavelength. This means that long wave signals can travel further distances, but they are also more susceptible to interference from natural and man-made obstacles.

3. What makes long wave radio better for certain types of transmissions?

Long wave radio is better for transmitting certain types of signals, such as low frequency radio waves used for navigation and time synchronization. This is because these signals can penetrate through obstacles like buildings and mountains, making them more reliable for these purposes.

4. Can long wave radio be used for broadcasting?

Yes, long wave radio can be used for broadcasting, but it is not as popular as other forms of radio broadcasting such as FM or AM. This is because long wave signals have lower sound quality and are more susceptible to interference, making them less desirable for entertainment purposes.

5. Are there any disadvantages to using long wave radio?

One major disadvantage of long wave radio is that it requires larger antennas and more power to transmit and receive signals. This can make it more expensive and less practical for certain applications. Additionally, long wave signals are more prone to interference, making them less reliable in certain situations.

Similar threads

  • Special and General Relativity
Replies
11
Views
295
  • Other Physics Topics
Replies
5
Views
2K
Replies
10
Views
3K
  • Introductory Physics Homework Help
Replies
6
Views
252
  • Science and Math Textbooks
Replies
7
Views
2K
Replies
2
Views
6K
Replies
31
Views
2K
Replies
1
Views
763
Replies
3
Views
1K
Back
Top