Becoming a student member of IEEE

AI Thread Summary
Joining IEEE as a student member can enhance scholarship applications and resumes, especially if one takes on leadership roles within the organization. Active participation, such as serving on the executive board or organizing events, demonstrates commitment and leadership, which are valued by employers. Networking opportunities through IEEE events can lead to internships and job prospects. Additionally, joining prestigious academic societies like Tau Beta Pi can further bolster applications. Overall, being an engaged member of IEEE is beneficial for both personal development and professional advancement.
pete5383
Messages
85
Reaction score
0
Hey everyone. I'm a sophomore in Electrical Engineering, and loving it (except for the homework...and tests...). Anyways, it's almost time for me to be applying for scholarships (well, in a couple months), and I was thinking about applying to IEEE as a student member. I was wondering if anyone has any opinions on if its helpful or not, informational wise, and also for scholarships/resumes? And also, are there any other organizations that I should look into joining to bolster my scholarship chances? I mean, don't take it that to mean that I'd join just to make myself look better, I also want it to be helpful to me as an engineer. Thank you :)
 
Engineering news on Phys.org
I am interested in this also. I would love to see some ideas about it
 
I joined IEEE somewhere in my undergrad, and was the chairperson of our student chapter for my senior year. Being a member is probably a plus on your applications and resume, but being a very active chairperson of your local chapter shows leadership. I helped organize field trips each term to prospective employers (mostly HP), and we had faculty mixers, etc. Consider running for chairperson of your local IEEE chapter.

As for other societies, the ones that matter are the ones that you earn your way into. Like Tau Beta Pi and other academic societies. Those definitely count on scholarship and job applications.
 
Good question.

I'm a sophmore EE and I'm the VP of our IEEE organization. It's a definite plus to join. Also, go to the events, because you can also network with individuals and other industry professionals for internship and also job opportunties. I'm also the student chair for the regional IEEE section. It's a definite plus to join those organizations.

Remember, its one thing to be a "member" and another to run the thing. Don't get me wrong, being a member is completley fine, and is what IEEE has been built from, but if you want to appeal more than just being a member, join the Eboard. Anyone can pay the $30 for students and be a member AND NEVER go to the meetings. I've seen it happen.

Bottom line: Be active, join the E-board.
 
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top