Surge Protector - strange reaction to light sources?

AI Thread Summary
The indicator lights on the power strips react to light sources by shining red during the day and turning off in the dark unless illuminated by another light. This behavior is typical of aging Neon lamps, where increased ionization threshold voltage causes the lights to flicker in sunlight and respond to external light sources. The phenomenon occurs because external light adds energy to the gas, lowering the threshold voltage needed for illumination. Neon lamps generally have a lifespan of 2000 to 25000 hours, with performance degrading over time, particularly with higher current use. Quality control issues are noted, as many lamps show signs of dimming or failure after extended use.
cf879
Messages
1
Reaction score
0
Surge Protector -- strange reaction to light sources?

We have 2 power strips in our home in which the indicator lights both react to a light source in the following manner: during the day (in the presence of sunlight) the indicator lights shine red with a small flicker every now and then. In the dark, the indicator lights are off unless a light is shone on them, say from a flashlight etc. whereupon they light up red. When the flashlight or other light source is turned off or covered, they go off again. What in the world could cause the indicator lights to react in such a manner?
 
Engineering news on Phys.org
That is typical of Neon lamps at their end-of-life. As they age their ionization threshold voltage increases. The external light adds a little bit of energy to the gas, lowering the threshold voltage.

This can also be demonstrated with new Neon lamps by applying a voltage just below threshold and then shining a bright light on them.

p.s. Typical Neon lamp lifetime is 2000+ to perhaps 25000 hours and decreases with increased current. I have about a dozen outlet strips here with about 20000 hours on them. One lamp has failed and 8 others are very dim. Quality control seems to be lacking.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Beauty of old electrical and measuring things, etc.'
Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
Back
Top