Natural response and step response

AI Thread Summary
In a circuit with a current source in parallel with an inductor, resistor, and capacitor, the behavior is not strictly classified as a natural or step response. A step response occurs when a sudden change, like a switch being flipped, introduces a new source to the circuit. Conversely, a natural response refers to the behavior of the circuit due to initial conditions, where energy stored in capacitors or inductors dissipates over time. If the current source has a step function, it will create a step response; otherwise, the circuit's behavior is simply a result of its configuration. Understanding these concepts is crucial for analyzing circuit dynamics effectively.
2slowtogofast
Messages
134
Reaction score
1
ok i need some clarification if you have a circuit where a current source is in parallel with an inductor a resistor and a capacitor is this considered a natural response or a step response. I guess i thought a step response is if a switch is switched and a source is added then it is a step response not if it was there the whole time.
 
Engineering news on Phys.org
Not sure what a "natural response" is... Perhaps it means the steady-state behavior since "step response" is pretty much what you describe: how the circuit behaves when a sudden change in voltage or current is applied.
 
2slowtogofast said:
ok i need some clarification if you have a circuit where a current source is in parallel with an inductor a resistor and a capacitor is this considered a natural response or a step response.
Neither. It's just considered a circuit.

If the current source contains a step then there will be a step response. If there are nonzero initial conditions then there will be a natural response.
 
natural response means the a capacitor/inductor is discharging such that after a long time, the voltage and currents approaches 0

step response is when a source will try to charge the inductors capacitors such that after a long time, the capacitors/inductors connected will be charged. if the capacitors/inductors have high initial voltage/current than what the source has to offer they can discharge until it reaches a steady charged state with a lower voltage/current. please correct me, this is how i understand step and natural response
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top