Discharging a capacitor - the Van Allen radiation belt

AI Thread Summary
The Van Allen radiation belts consist of an inner belt primarily made of protons and an outer belt of electrons, attributed to differences in mass and charge density. The discussion highlights that charge separation within the belts creates a potential difference, but significant events like solar storms or cosmic phenomena would be required for a discharge. Factors such as the Earth's magnetic field trap particles, preventing them from easily escaping, and the considerable distance between the inner and outer belts diminishes the electrostatic forces at play. Additionally, the high-speed movement of particles complicates the system beyond simple electrostatic behavior. Discharges from the belts occur gradually through interactions with the atmosphere rather than sudden events.
DrClapeyron
I've seen inner and outer Van Allen belt drawings that have the inner belt consisting of protons and the outer belt consisting of electrons. I am guessing this is due to differences in the mass density or the charge density differences of the two.

So we have charge separation in the Van Allen belt, a potential difference, and a build up of this charge is all we need to reach the critical voltage to cause a current to flow.

What would it take for the Van Allen radiation belt to discharge: solar storm, cosmic dust, distant gamma ray bursts? Anyone have data on the volume, charge density and other physical properties of the Van Allen belt?

Because I was wondering if a possible bolide impact or volcanic eruption could cause a discharge. These would have to be significantly large events so I am trying to find out just how big they would have to be.
 
Physics news on Phys.org
I am not a expert in the area, but I don't think there are huge discharges between the outer and inner belts for the following reasons:

1) The particles in the belts are not just floating is space. They are trapped by the Earth's magnetic field. That is why the belt's exist in the first place and the why the particles don't just float away or gravitate to Earth's surface.

2) The distance between the rough outer edge of the inner belt and the inner edge of the outer belt is about 10,000 km. This distance is so large that the electrostatic force between a single electron and a single proton this far apart is negligible.

3) The particles in the belts are moving at high speed, so you can't treat the system as an electrostatic system like a capacitor.

4) The belts discharge gradually (leak) by interacting with the atmosphere.
 
Thread 'Inducing EMF Through a Coil: Understanding Flux'
Thank you for reading my post. I can understand why a change in magnetic flux through a conducting surface would induce an emf, but how does this work when inducing an emf through a coil? How does the flux through the empty space between the wires have an effect on the electrons in the wire itself? In the image below is a coil with a magnetic field going through the space between the wires but not necessarily through the wires themselves. Thank you.
Thread 'Griffith, Electrodynamics, 4th Edition, Example 4.8. (Second part)'
I am reading the Griffith, Electrodynamics book, 4th edition, Example 4.8. I want to understand some issues more correctly. It's a little bit difficult to understand now. > Example 4.8. Suppose the entire region below the plane ##z=0## in Fig. 4.28 is filled with uniform linear dielectric material of susceptibility ##\chi_e##. Calculate the force on a point charge ##q## situated a distance ##d## above the origin. In the page 196, in the first paragraph, the author argues as follows ...
Back
Top