Electricity from high voltage lines

AI Thread Summary
Taking electricity from high voltage lines to power homes is technically possible but highly illegal and dangerous. The discussion highlights that while one could potentially connect to these lines without a meter, it poses significant risks, including electrocution and legal consequences. Electrical companies routinely monitor lines, making such unauthorized connections short-lived. Due to liability concerns, the forum will not provide guidance on the procedures for this. Engaging in such activities is strongly discouraged.
rtwohey
Messages
1
Reaction score
0
I have recently read about people who have successfully taken electricity from high voltage lines and used it to power their homes. Is this possible? What voltage, current and power can you get from it? What extra equipment is needed to make this work successfully?
 
Engineering news on Phys.org
Due to the potential hazards and legal ramifications of this question I am locking it.
 
I'm sure it's possible. You get power from the power lines to your house legally. There is nothing stopping you from getting it illegally. I think that all it would need is an unscrupulous electrician to hook up your house without an electrical meter.

It would be extremely dangerous because you couldn't get the electical company to cut power to the wires while you hook them up, and it wouldn't last long because the electrical company sends crews around regularly to check meters for billing purposes.

However, as Integral has said, we will not host discussions into the actual procedures to do so due to liability reasons.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Replies
3
Views
1K
Replies
1
Views
380
Replies
23
Views
5K
Replies
31
Views
2K
Replies
8
Views
2K
Replies
10
Views
2K
Replies
32
Views
2K
Replies
7
Views
2K
Back
Top