Help with DVR System Setup for Ambulance

  • Thread starter Thread starter tedkeano16
  • Start date Start date
  • Tags Tags
    System
AI Thread Summary
The discussion focuses on setting up a DVR system for an ambulance, which includes a rear camera, a dome camera for the interior, and a panic strip for recording. The user seeks advice on the appropriate video splitter leads and a 12-volt five-pin relay for the system. It is noted that a powered video splitter is necessary, as traditional splitters do not suffice for video signals. Suggestions include ready-made switches and custom relay options available from electronic suppliers. The conversation emphasizes the importance of selecting the right components for effective DVR functionality in emergency vehicles.
tedkeano16
Messages
1
Reaction score
0
I have been left a rough circuit diagram of an dvr system for an ambulance by a colleague who has since moved jobs .what the unit consists of is a camera on the rear of the vehicle with a monitor up front displaying the outside of the vehicle when reversing. a dome camera in the back of the vehicle that is looking down on the inside of the vehicle and the monitor up front can display this a panic strip running on the ceiling of the rear of the vehicle when pressed will start recording the inside rear of the vehicle i have a diagram of this which i can forward on what i need to know is what type of video splitter leads would i use and what type of 12volt five pin relay to use if it is not clear what i need i can send on the circuit diagram
 
Engineering news on Phys.org
Video splitter doesn't seem to fit with what you are asking for and unlike audio it would need to be a powered device, not a cable.

They sell ready made switches like this that could probably be used as is or modified.
http://www.nextag.com/Startech-SVID...rices-html?nxtg=38e60a1c0528-3C40B8BC6B4F5DB4

Some potential roll your own relays
http://search.digikey.com/scripts/DkSearch/dksus.dll?Cat=1049448;keywords=relay

There are also various electronic switches w\that can be wired up.
 
Last edited:
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top