IEEE Project Format: What is the Standard?

AI Thread Summary
The discussion focuses on the need for an IEEE standardized format for a project report on pattern recognition. A user inquires about the specific format required for submission, prompting others to provide resources. One participant shares a link to a sample paper that outlines the two-column format used for IEEE conference proceedings. The conversation emphasizes the importance of adhering to IEEE guidelines for project submissions. Overall, the thread serves as a resource for students seeking clarity on IEEE formatting standards.
sgsawant
Messages
30
Reaction score
0
I have to submit a project report on a pattern recognition project I am working on this semester. The professor wants me to submit the same in some IEEE format.

Is there an IEEE standardized format for project reports? If yes can someone post links explaining the same format?

Regards,

-sgsawant
 
Engineering news on Phys.org
Preparation of Papers in Two-Column Format for Conference Proceedings Sponsored by IEEE. J. Q. Author.
"www.ieee.org/portal/cms_docs/pubs/confpubcenter/pdfs/samplems.pdf"[/URL]
This should help.

BTW Welcome to PF
 
Last edited by a moderator:
Thanks!
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

Similar threads

Replies
16
Views
3K
Replies
37
Views
4K
Replies
8
Views
3K
Replies
5
Views
2K
Replies
15
Views
2K
Replies
32
Views
2K
Back
Top