A massless, frictionless pulley is suspended from a rigid rod

AI Thread Summary
In the discussed scenario, a massless, frictionless pulley supports two masses, m (50 kg) and M (60 kg), connected by a cord. The force analysis reveals that the net force equation is Mg - mg = (m + M)a, leading to the conclusion that the acceleration of mass m is upward and that of mass M is downward. The acceleration for mass m is calculated as (M - m)g/(M + m), while mass M experiences the same magnitude of acceleration but in the opposite direction. The direction of acceleration is contingent on the defined coordinate system, with the participant defining positive as upward. Thus, mass m accelerates upward while mass M accelerates downward.
Soaring Crane
Messages
461
Reaction score
0
A massless, frictionless pulley is suspended from a rigid rod. Two masses, m (50 kg) and M (60 kg), are suspended on either side of the pulley, respectively, by a light, inextendable cord. Determine the accelerations of the masses.

I drew the force diagrams of both; there is an upward tension force and a downward gravity force in each. Mg - mg = (m + M)a. Now acceleration of block m is (M - m)g/(M + m) upward and block M's acceleration is the same but downward. So does m have a positive acceleration while M has a negative acceleration?

Thanks.
 
Physics news on Phys.org
Could be either, it depends upon how you define your coordinate system. Is postive up or down?
 
I guess I define positive as going up on the coordinate sys. In the problem, m is pulled up while M goes down.
 
I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
Back
Top