Bending Stresses on Male Component in Tapered/Interference Fits

  • Thread starter whistleboy
  • Start date
  • #1
I'm looking for some help understanding bending stresses and stress concentrations in Morse Tapers (or any press-fit or interference-fit geometry). Specifically, I'm trying to understand the influence of a slot (and orientation of the slot) in the female component of a Morse Taper on the stresses developed in the male component when the male component is subject to lateral bending. I'm trying to find a relatively simple way to express the stresses acting on the male component mathematically as well as determine WHERE the maximum stresses would develop on the male component within the taper junction. Thank you so much!
 
Last edited:

Answers and Replies

Related Threads on Bending Stresses on Male Component in Tapered/Interference Fits

Replies
3
Views
4K
Replies
3
Views
3K
Replies
2
Views
2K
Replies
2
Views
1K
  • Last Post
Replies
1
Views
749
Replies
1
Views
1K
Replies
3
Views
3K
Replies
2
Views
807
Replies
3
Views
1K
  • Last Post
Replies
1
Views
594
Top