Boundary Type for Acoustic Simulation in GAMBIT?

  • Thread starter Thread starter acoustic
  • Start date Start date
  • Tags Tags
    Boundary
AI Thread Summary
For simulating the flow inside a tube with one closed end and a speaker-driven open end in GAMBIT, selecting the appropriate boundary type for the speaker end is crucial. The speaker generates oscillating pressure and velocity, influencing the acoustic field within the tube. Users recommend using a "pressure outlet" boundary condition for the speaker end to accurately represent the oscillating behavior. The other boundaries can remain as "wall" types to reflect the closed end and tube walls. Proper boundary selection is essential for achieving realistic acoustic simulations.
acoustic
Messages
11
Reaction score
0
Hi everyone,

I would like to simulate the flow inside a tube having one closed end and the other end is driven by a loud speaker.

The speaker creates an oscillating pressure (and velocity) which will have an effect on the acoustic field inside the tube.

so to be clear: which boundary type shall I choose in GAMBIT for the speaker end. (the other boundaries are "wall" type).

Thank you in advance for your help
 
Engineering news on Phys.org
Help pleasezzzzz
 
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »

Similar threads

Modeling Air Compression Cylinder
Replies
45
Views
5K
I Standing Waves by Reflection: Losses of the Reflected Wave
Replies
16
Views
2K
What constitutes a closed end in acoustic resonance in tubes
Replies
8
Views
4K
Where are the pressure nodes on a standing acoustic wave in water?
Replies
7
Views
2K
Flow/pressure and venturi question
Replies
26
Views
3K
Doublet flow in Fluid Dynamics between two spheres or cylinders
Replies
0
Views
1K
Sound standing waves paradox....
Replies
1
Views
2K
What causes an increase in boundary layer thickness in fluid flow?
Replies
4
Views
2K
Time to empty gas cylinder (problem worked, but would like feedback)
Replies
7
Views
3K
I Are 1D Longitudinal Waves Reflected at an Open End?
Replies
11
Views
1K

Hot Threads

Recent Insights

Back
Top