Bungee Jump - Potential and Kinetic Energy

AI Thread Summary
The bungee jumper needs to calculate the required length of bungee cord to stop 3 meters above the ground, given a mass of 55 kg and a spring constant of 22 N/m. Initial calculations suggested a cord length of 57.3 meters, but further discussion clarified that the effective length should be 9.7 meters after accounting for the jumper's stopping height. For part b, if the spring constant is 10% lower, the jumper's speed upon hitting the ground was initially miscalculated, with the correct answer being 7.95 m/s. The conversation emphasized the importance of correctly interpreting the stopping condition and the extension of the bungee cord.
kdm06
Messages
14
Reaction score
0

Homework Statement



A bungee jumper needs to calculate how much bungee cord to attach to herself so that it will bring her to rest 3m above ground. The spring constant of the bungee cord is 22 N/m, and she has a mass of 55kg. Neglect the bungee cord's mass.
a. How long a bungee cord is required?
b. If she uses the length calculated in a but the spring stiffness is 10 percent less than it was advertised to be, how fast will she hit the ground?

The bungee jumper is standing 70m above the ground.

Homework Equations



PE(g)=mgh
PE(sp)=1/2kx^2
KE=1/2mv^2

The Attempt at a Solution



For part a I used this equation:
PE(g)=PE(sp)+PE(g)
55(9.81)(70)=1/2(22)*x^2+(55)(9.81)(3)
x=57.3 m

For part b I used this equation:
PE(g)=PE(sp)+KE
55(9.81)(70)=1/2(19.8)(57.3)^2+1/2(55)v^2
v=13.835 m/s

The correct answer is 7.95 m/s for part b.
So I am not sure if my part a is wrong or if I am not setting up my equation correctly.
 
Physics news on Phys.org
Could someone please look over my work? I may have set it up incorrectly.
 
For part a, 'x' is the extension in the spring not it's total length.
 
That's some wacky stuff if its spring constant is independent of its length.
 
Yes, but it also has zero mass!
 
So, did I go about part a incorrectly or did I substitute the incorrect amount for part b?
 
Yeah, part a) isn't right.

She needs to come to rest 3m above ground. So conservation of energy won't work here for part a).

when she comes to rest, energy has been lost to heat/friction etc...

What is her acceleration when she comes to rest? hence what is the net force acting on her when she comes to rest? so what is the extension of the bungee cord?
 
Since acceleration isn't given, should I use F=ma and find acceleration?
Then use a constant accelaration equation to find the cord extension?
 
kdm06 said:
Since acceleration isn't given, should I use F=ma and find acceleration?
Then use a constant accelaration equation to find the cord extension?

What is the acceleration of a body at rest?
 
  • #10
learningphysics said:
She needs to come to rest 3m above ground. So conservation of energy won't work here for part a).
By "come to rest" I assume they meant momentarily come to rest, not be at equilibrium. (Otherwise she'll probably smack into the ground!) So I see nothing wrong with using conservation of energy.
 
  • #11
Oh...sorry! OK...so the net force acting on her at rest is weight. So would the extension just be 67 m?
 
  • #12
Doc Al said:
By "come to rest" I assume they meant momentarily come to rest, not be at equilibrium. (Otherwise she'll probably smack into the ground!) So I see nothing wrong with using conservation of energy.

Yes, you're right. :smile: For some reason I thought that she does smash into the ground in this problem!

sorry about that kdm! your initial solution to part a) is fine I believe, except you need to get 70m - 3m - 57.3m = 9.7m I think.

sorry again.
 
  • #13
ok. so for part a the length of the cord would be 9.7?
but for part b i understood it as she does hit the ground since the spring stiffness is 10 percent less. however would i use 9.7 as the 'x' in PE(sp) and use 57.3 as the 'h' in PE(g)?
 
  • #14
kdm06 said:
ok. so for part a the length of the cord would be 9.7?
but for part b i understood it as she does hit the ground since the spring stiffness is 10 percent less. however would i use 9.7 as the 'x' in PE(sp) and use 57.3 as the 'h' in PE(g)?

The amount the bungee stretches for part b) is 70m - 9.7m = 60.3m.

so this would be your equation:

55(9.81)(70)=1/2(19.8)(60.3)^2+1/2(55)v^2
 
Back
Top