Can i have a idea about waste heat recovery projects ?

AI Thread Summary
Waste heat recovery projects can be explored through various applications, such as utilizing waste heat from landfills or brake systems. Providing a clear and detailed context for inquiries is essential to receive meaningful assistance. The initial request lacked sufficient information, making it difficult for others to engage effectively. Elaborating on specific challenges or goals can enhance the quality of responses. Clear communication is key to fostering productive discussions in waste heat recovery.
roshni
Messages
2
Reaction score
0
so that getting some use through waste...
 
Engineering news on Phys.org
sure...
 
can u please give me idea...?
 
Dude, you hardly explain yourself or your question at all. When you need people's help, you should try to elaborate on the problem and put it into context. Your request is barely a sentence so why should people take you seriously?

At any rate, check out waste heat from landfills or waste heat from brakes.
 

Thread 'Race car suspension Class'

Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
View full post »

Thread 'Cantilever help'

I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
View full post »
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'

Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
View full post »

Similar threads

Calculating heat recovery from engine exhaust gases
Replies
2
Views
3K
Steam Turbine Design for Waste Heat Recovery Plant
Replies
1
Views
1K
Optimum boiler pressure for Waste heat recovery system
Replies
4
Views
2K
Mechanical guy needs help with endothermic reaction and heat decomposition
Replies
8
Views
1K
Pulling a vacuum on a heat pump with a recovery machine
Replies
1
Views
3K
Improving heat transfer in domestic hot water tank?
Replies
15
Views
4K
Help me heat up a powder coating oven (made out of an old steel cabinet)
Replies
9
Views
2K
Mechanical/Aerospace Engineering Undergrad Senior Design Project
Replies
3
Views
2K
Looking for ideas for a propane burner design
Replies
4
Views
1K
Hot Air to Cold Oil Heat Exchanger
Replies
6
Views
2K

Hot Threads

Recent Insights

Back
Top