Car reading 17V+ in the battery when running, how to fix?

AI Thread Summary
The discussion centers on a 2004 Toyota Matrix experiencing an abnormal battery voltage reading of 17.2V while running, which is significantly higher than the normal range of 13-14V. This high voltage could lead to battery overheating and potential electrical damage, prompting the owner to seek guidance on diagnosing and fixing the issue. Participants suggest that the voltage regulator, which controls the alternator's output, is likely the culprit and recommend testing or replacing it. It's emphasized that the car should not be used until the problem is resolved to prevent further damage. Overall, addressing the voltage regulator is crucial for maintaining the vehicle's electrical system integrity.
Mescapium
Messages
1
Reaction score
0
Hi, I have a 2004 Toyota Matrix with 270 000km. It's working great but today when i started my car the battery was going up to 17.2V (i have a battery voltage reader in the car at all time). It's the first time it went up there, it usually stays in the 13-14V. I know something is wrong and I want to fix it before it breaks something. I made some reasearch already and i read it could be the voltage regulator circuited between the alternator and battery. I don't know much about car's electrical system and my electric classes are a little bit far (still i am supposed to have some basic knowledge). So i'd like to know precisely what's the problem and how to fix it. Or some help or guidance, thanks a lot for any help provided !
 
Engineering news on Phys.org
Mescapium said:
Hi, I have a 2004 Toyota Matrix with 270 000km. It's working great but today when i started my car the battery was going up to 17.2V (i have a battery voltage reader in the car at all time). It's the first time it went up there, it usually stays in the 13-14V. I know something is wrong and I want to fix it before it breaks something. I made some reasearch already and i read it could be the voltage regulator circuited between the alternator and battery. I don't know much about car's electrical system and my electric classes are a little bit far (still i am supposed to have some basic knowledge). So i'd like to know precisely what's the problem and how to fix it. Or some help or guidance, thanks a lot for any help provided !
Note the alternator’s make and model. Most modern units have a built-in regulator that should cut off above 14.4V or so.

17.2V, if correct, will be boiling your battery and causing untold electrical havoc - best not to use the car until you have it sorted.
 
might this fit in DIY thread ?
 
In my experience voltage regulator is a prime suspect. As Guineafowl wrote if it is a lead battery high voltage can mean heating it till it the acid starts to boil, it stinks like hell and corrodes the metal around.

At least that's what I had to deal with about 15 years ago, in the end I had to replace both the regulator and the battery.
 
  • Like
Likes jim hardy
EDIT When it's working, an..
Alternator should not produce more than about 14.5 volts.
It has an internal voltage regulator to control its output voltage.
It should look like this
upload_2018-8-25_17-42-34.png


and be mounted on the alternator. probably on end opposite the pulley.

Try unplugging the wire that plugs into that receptacle then start the car.
Voltage should read around 12 .

One can replace just the regulator but it'll probably cost you nearly the same as a whole alternator.

good luck

old jim

(Sorry)
 

Attachments

  • upload_2018-8-25_17-42-34.png
    upload_2018-8-25_17-42-34.png
    16.7 KB · Views: 934
Last edited:
  • Like
Likes Mescapium and davenn
Borek said:
At least that's what I had to deal with about 15 years ago, in the end I had to replace both the regulator and the battery.
Me too, about 1974. The exact same problem. In a 1947 Beech Bonanza over Wyoming. Flew from there to Southern California with the electrics shut off. Fortunately, airplane engines have magneto ignition, so can run forever without a generator.
 
  • Like
Likes Borek
jrmichler said:
The exact same problem. In a 1947 Beech Bonanza over Wyoming.

Ahhh Nostalgia. My good friend and mentor had one of those... Amazing machine.

did yours have the Jordan-Flanagan truss mod ?
 
jim hardy said:
Alternator should not produce more than about 14.5 volts.

Even with a malfunctioning regulator that drives the field?
 
  • #10
anorlunda said:
Even with a malfunctioning regulator that drives the field?

hmm. should have prefixed with "A properly functioning..."

will fix it

<chagrin icon>
 
  • #11
jim hardy said:
did yours have the Jordan-Flanagan truss mod ?

Probably not. It was a rental on leaseback, and the FBO did not believe in spending too much on maintenance. The overcharging was a known problem, and I was told to just add water to the battery.
 
  • #12
jrmichler said:
the FBO did not believe in spending too much on maintenance. The overcharging was a known problem,

Wow !
"Continued VFR...".
 
Back
Top