Cascading Multiplexers: A Tutorial

  • Thread starter Thread starter JasonJo
  • Start date Start date
  • Tags Tags
    Tutorial
AI Thread Summary
Cascading multiplexers involves connecting the outputs of multiple MUXs to the input of another MUX, effectively creating a larger multiplexer with increased selection bits. The specific configuration and design depend on the intended application or system requirements. Resources from leading manufacturers often provide valuable tutorials and guidance on this process. For example, Lucent offers a helpful link for further exploration of digital circuit multiplexers. Understanding the cascading technique is essential for designing complex digital circuits.
JasonJo
Messages
425
Reaction score
2
how do you cascade MUX's??
 
Engineering news on Phys.org
SDH MUXs? The websites of leading manufacturers should give you steer; many had pretty good tutorials on this kind of thing last time I looked. Here's a Lucent link from which you may start:
http://www.lucent.com/products/solution/0,,CTID+2018-STID+10477-SOID+669-LOCL+1,00.html
 
Last edited by a moderator:
i mean digital circuit multiplexers
 
Originally posted by JasonJo
how do you cascade MUX's??

usually just connect the output of several MUXs to the input of another one. You get a bigger MUX (bigger I mean with more selection bits). But of course it finally depends on what are you trying to build...
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »

Similar threads

Peltier cell in series both electrically and thermally
Replies
5
Views
2K
Can all the multiplexers work for any number of variables given?
Replies
1
Views
1K
Cascade connection of induction motors
Replies
6
Views
7K
How does a digital multiplexer work in communication systems?
Replies
5
Views
3K
How would you compartmentalize this circuit?
Replies
31
Views
3K
Question: Voltage Multiplier Safety
Replies
9
Views
3K
Hello everyone, can somebody with cascode amplifier
Replies
4
Views
2K
Op-amp compensation of cascade fudges audio signal oddly
Replies
3
Views
2K
Turbulence and why eddy breakups take place?
Replies
4
Views
2K
Frequency Division Multiplexing in Telephone
Replies
7
Views
4K

Hot Threads

Recent Insights

Back
Top